Draw and measure on the project map
Before, a project's drone inspections had their own tabs on the project page, and you could draw and measure on a solar inspection's map. Now you open inspections from Inspections, under All sites in the Map tab's side panel (on a phone, under Layers), and Project map takes you back. Drawing and measuring are done on the project map only. In solar inspection Setup and finding review, the map shows block outlines, panels, strings and where findings are, but you can no longer draw, reshape or move them there; a finding can still be put on a panel, or moved to another, by picking the panel. This change was not announced ahead, as it should have been.
What to do, by December 1, 2026
- Tell your team that drawing and measuring are now done on the project map, and that in solar inspection Setup and finding review they can no longer draw, reshape or move anything on the map, only pick the panel a finding is on.